The final glass clean after renovation
Renovation can leave glass looking dull even after the rooms have been cleaned. Fine building dust gathers at edges and in channels, while protective films, labels and splashes may need individual attention. We inspect the glazing and identify the type of contamination before setting the scope. New panes and coated glass need particular care, and any available manufacturer instructions are relevant. The work is planned around the remaining trades so freshly cleaned windows are not immediately covered again. This service concerns the agreed glazing, not a complete builders-clean of the property.
No blanket scraping of new glass
Paint specks, cement residue and adhesive are not all removed in the same way. Scraping every pane can cause damage, especially where glass condition, coatings or contamination are uncertain. We assess the deposit and surface before proposing treatment, and difficult areas may require a test or specialist advice. Existing scratches should be distinguished from dirt before work starts. We do not promise to remove every mark or restore damaged glass. If an appropriate method cannot be established, the affected contamination is excluded rather than removed at the expense of the surface.
Frames, channels and protected edges
A post-renovation clean often needs more than the broad glass faces. Dust collects in accessible channels, under frame edges and around handles, while tape residue can remain on coated surfaces. We list these areas separately and account for the finish of the frame. Cleaning does not include removing failed sealant, repairing damaged coatings or dismantling door mechanisms. Heavy debris and unfinished building work should be cleared by the relevant trades before the final clean. Any protective film still needed during ongoing works should remain in place until its removal is properly agreed.
Timing the handover clean
The best scope is based on a sufficiently finished site with safe access and the remaining works clearly identified. We agree which panes are ready, whether both faces are accessible and whether follow-up cleaning may be needed after other trades return. Villas, renovated apartments and commercial units have different access and handover constraints. Our regular window-cleaning service can maintain the finish afterwards, but the initial construction clean is a separate job. Photos of the glass and residue help establish the requirements; they do not replace an assessment where the surface or contamination is uncertain.
Paint spots, adhesive and cement on new glass
Construction marks need to be identified before a method is chosen. Loose dust, adhesive, paint and cement residue do not respond to the same treatment, and some glass has coatings that can be damaged by unsuitable products or tools. We define the contaminated surfaces and assess the finish rather than applying a blanket scraping approach. For a renovation in Loulé or a completed property in Almancil, provide the glazing details and any manufacturer care instructions available. Existing scratches are a separate condition, not something that cleaning can reverse. Aggressive restoration is not included by implication in the final clean.
A final clean before furniture or guests arrive
The timing of a post-building clean affects the result. Work should be planned after the dusty activity that would immediately re-soil the glass, with access to the rooms and external elevations agreed. We separate panes, frames and tracks so remaining construction dust is not mistaken for an unfinished glass clean. For a refurbished rental in Albufeira, the handover scope should state what can be completed before occupancy and any glass that needs further specialist assessment. This is not general rubble removal or a complete property deep clean. Once the initial condition is addressed, maintenance visits can be scoped differently.
